MATEC CT-101

$600.00

Steel plate calibrated with a curved ruler, anti-friction coating. Nylon rings are inserted into the holes for centering and so as not to scratch the bobbin cases. The probes have magnets for holding on the surface of the plate. The probes are duralumin anodized, but the anode is removed from the working surfaces to avoid damage to the heads. All Bars are individually calibrated according to Ioganson’s tiles.

If you don’t have test tapes and other electronic instruments to fine-tune, or you don’t necessarily need to set up the record perfectly. Then our Tool will help you set up the recorder quite well without everything else!

          • ↓BARS↓
  • Standard “Tape guide height” the tape and heads height gauge.
  • Tape guide height” (with protrusions )Head height gauge for very clever for the Nakamichi decks with the slots.
  • Adjustment head 90″Perpendicular to the working surface of the heads
  • Erasing head for Nakamichi”For the height of the erase head only Nakamichi deck 1978-1992years.

Limited Edition

12 in stock

Category:

Description

Setting the calibration tool in the
transport to adjust the parameters.



This bar is used to set the height of the belt direction.

 

This bar is used to set the perpendicularity
of the working surface of the heads relative
to the plane of the cassette.

 

This bar has a red dot. It is used to set the
depth of insertion of the heads into the cassette.

 

This bar has tabs on the edges for easy adjustment
of heads that have slots on the edges of the tape.
These heads are usually installed in
nakamichi transports.

 

The calibration plate is made of steel and
has a black protective and anti-friction
coating.
Nylon rings are inserted in the holes
to protect against damage to the transport components
and to center the plate in the transport.

 

The Adjustment Head Bar must be positioned
so that it fits into the notch when closed.

 

Packing box made of bamboo.
Closes with magnets. Bottom has soft feet
so that the box does not slide on the table.

Reviews

There are no reviews yet.

Be the first to review “MATEC CT-101”

Your email address will not be published. Required fields are marked *

Related products